4.5 Inch Lift Kit | Ram 3500 4WD (2013-2018) | 3 Inch Rear Block | w/ Nitro Series Shocks | Zone Offroad

This configuration pairs a 3-inch rear block kit with Nitro Series shocks. The Nitro Series features an internal floating piston (IFP) monotube design with a large 5/8-inch hard chrome plated heat-treated alloy steel shaft, race-developed high-flow piston design, application-specific valving, and a long-lasting silver coated finish.

Overview

This 4.5-inch lift kit from Zone Offroad is designed for the 2013–2018 Ram 3500 4WD. The kit includes full-length replacement coil springs, radius arm relocation brackets, steering correction components, and a rear block kit to level the truck's stance. It provides clearance for tires up to 37 inches.

Features

• Corrects suspension, steering, and drive-line geometry for improved on-road handling and off-road performance
• Full-length replacement coil springs add ride height while maintaining ride quality
• High-strength control arm relocation brackets correct suspension geometry and add rigidity
• Includes everything needed for front and rear lift
• Provides clearance for up to 37-inch tires

Specifications

• Front Lift Method: Coil Spring & Drop Bracket
• Front Lift Height: 4.5 inches
• Rear Lift Method: Block
• Rear Lift Height: 2 inches (2-inch block option) or 3 inches (3-inch block option)
• Shocks Included: Yes

Installation

• Estimated Installation Time: 5 hours
• Installation Difficulty: Moderate

Important Notes

• Fits trucks equipped with the 6.4L gas engines.
• Front drive-line vibration may occur at speeds over 35 mph when in 4WD. If this occurs, install the appropriate optional t-case indexing kit. Models with a 6-bolt transfer case use part # D5623. Models with an 8-bolt transfer case use part # D5813.
• Does NOT work for models with factory rear airbag suspension.
• Two-piece rear drive shaft: Add a carrier bearing drop kit to reduce post-lift driveline angles and avoid/eliminate driveshaft vibration.
• 6.4L Gas models will require exhaust modification to clear the front driveshaft.
• 5.7L Gas models may require modification.
• Factory wheels fit when paired with factory/original equipment tire size.
• This kit is not designed for dually models, but may be easily adapted to accommodate your truck.