4.5 Inch Lift Kit | Ram 3500 4WD Diesel (2019-2024) | 2 In Rear Block w/ Overload | 6-Bolt | FOX 2.0 Adventure Series | Zone Offroad

Configured with a 2 Inch Rear Block Kit With Overload, a 6-Bolt T-case indexing ring, and FOX 2.0 Adventure Series IFP monotube gas shocks. The FOX 2.0 Adventure Series features an internal floating piston (IFP) monotube design, a large 5/8-inch hard chrome plated heat-treated alloy steel shaft, race-developed high-flow piston design, application-specific valving, and a long-lasting clear anodized finish.

Overview

This 4.5 inch lift kit from Zone Offroad is designed for 2019–2024 Ram 3500 4WD diesel trucks. The kit includes everything needed to raise the front and rear of the truck, from full-length coil springs and radius arm relocation brackets to steering correction components and rear block lift. Clearance for up to 37 inch tires is achievable with this kit.

Features

• High-strength progressive rate front coil springs
• HD radius arm drop brackets to correct suspension geometry
• HD track bar relocation bracket to correctly position the front axle under the truck
• Forged drop pitman arm to correct steering angles
• Front sway bar correction to maintain handling performance
• HD transmission crossmember and T-case indexing ring to correct front driveline angles
• Choice of Nitro Series gas or FOX 2.0 Adventure Series IFP gas shocks
• Allows clearance for up to 37 inch tires

Specifications

• Front Lift Method: Coil Spring & Drop Bracket
• Front Lift Height: 4.5 inches
• Rear Lift Method: Block
• Rear Lift Height: 2 inches or 3 inches (depending on selected variant)
• Shocks Included: Yes

Installation

• Estimated Installation Time: 6 hours
• Installation Difficulty: Difficult

Important Notes

• Does not fit Dually Models with 8-bolt transmissions (Aisin).
• T-case indexing ring available for 6-bolt and 8-bolt equipped models — check vehicle before ordering.
• Will NOT fit Cab and Chassis models.
• Will NOT fit rear air-ride equipped models.
• Diesel models only.
• Will NOT fit Mega Cab Aisin Transmissions (8-bolt).
• Vehicles with a Manual Shift Transfer Case require a Manual T-Case Indexing Kit — add ZOND5409 in kit configuration.
• Trucks equipped with a 2-piece rear driveshaft require carrier bearing shim kit D5406 (not included with kit).
• The Ram 3500 has two different rear axle diameters. Measure your rear axle and select the appropriate rear kit for your vehicle.
• Kits come standard with a 6-bolt indexing ring. Ram's optional Aisin heavy-duty 6-speed transmission (available on 3500 trucks) uses a different transfer case mounting bolt pattern (8-bolt). The 8-bolt kit also includes an internal shaft seal extension and new shaft seal.