Configured for trucks with a 3-1/2-inch rear axle diameter, paired with FOX 2.0 Adventure Series shocks featuring a nitrogen-charged twin-tube design, 10-stage velocity-sensitive valving, dual-welded ends, self-lubricating seals, and a 2-inch diameter black powder-coated steel body.
Overview
This 6-inch lift kit is built to provide a full 6 inches of lift for clearance of up to 37-inch tires on 2009–2013 Dodge/Ram 2500/3500 4WD gas trucks. The kit corrects suspension and steering geometry so the truck drives and handles properly while delivering increased off-road capability.
Features
- 100% bolt-on design for straightforward installation
- High-strength control arm relocation brackets correct suspension geometry and add rigidity
Specifications
- Front Lift Method: Coil Spring
- Front Lift Height: 6 inches
- Rear Lift Method: Block
- Rear Lift Height: 4 inches
- Shocks Included: Yes
Installation
- Estimated Installation Time: 7 hours
- Installation Difficulty: Moderate
Important Notes
- Will work with Power Wagon models with the addition of sway bar link kit D5301. Power Wagon models came factory with a 2-inch taller ride height, so net lift gain will be 4 inches over stock.
- This truck was produced using rear axles of differing diameters; measure the diameter of your rear axle to ensure proper kit selection in configuration.
- Although rare, if you experience front drive-line vibration, install the optional transfer case indexing ring.
- This kit is not designed for dually models, but may be easily adapted to accommodate your truck. Please contact customer support and they will help you find a solution.
- Gas models may require modification to the front exhaust crossover pipe on the driver side when using the transfer case indexing ring.
- Two-piece rear drive shaft? Add a carrier bearing drop kit to reduce post-lift driveline angles and avoid/eliminate driveshaft vibration.
- Adding larger-than-stock wheels? Add front bumper spacers to your kit for additional clearance, as some wheel/tire combinations may not fully clear the bumper's stock location.
- Works on 2013 2500 with 4-link front suspension only.
- Will not fit 1-ton trucks.
Total Reviews (0)
Write the First Review!