Configured with FOX 2.0 Adventure Series shocks featuring a nitrogen-charged twin-tube design, 10-stage velocity-sensitive valving, dual-welded ends, self-lubricating seals, and a 2-inch diameter steel body with black powder coat finish.
Overview
This 4-inch lift kit is built for the 2006–2007 Dodge/Ram 2500 Power Wagon 4WD, providing enough clearance for up to 37-inch tires. Designed for everyday driving while remaining capable of handling off-road use.
Features
- 100% bolt-on design for easy installation
- High-strength control arm relocation brackets correct suspension geometry and add rigidity
Specifications
- Front Lift Method: Coil Spring
- Front Lift Height: 4 inches
- Rear Lift Method: Block
- Rear Lift Height: 2 inches
- Shocks Included: Yes
Installation
- Estimated Time: 7 hours
- Difficulty: Moderate
Important Notes
- If your truck has had the steering gear box changed and the sector shaft diameter measures approximately 1-1/2"–1-5/8", you will need part ZOND8404 in addition to this kit.
- This truck was produced using rear axles of differing diameters; measure the diameter of your rear axle to ensure proper kit selection and configuration.
- Although rare, if you experience front driveline vibration, install the optional transfer case indexing ring.
- This kit is not designed for dually models, but may be easily adapted to accommodate your truck. Please contact customer support for assistance.
- Two-piece rear drive shaft? Add a carrier bearing drop kit to reduce post-lift driveline angles and avoid or eliminate driveshaft vibration.
- Adding larger-than-stock wheels? Add front bumper spacers to your kit for additional clearance, as some wheel/tire combinations may not fully clear the bumper's stock location.
Total Reviews (0)
Write the First Review!