Configured with FOX 2.0 Adventure Series shocks featuring a nitrogen-charged twin-tube design, 10-stage velocity-sensitive valving, dual-welded ends, self-lubricating seals, black powder coat finish, and a 2-inch diameter steel body.
Overview
This 3-inch lift kit is designed to raise your 4WD 2010–2013 Dodge/Ram 2500 Power Wagon, providing clearance for larger tires. The kit includes all necessary components for a complete installation.
Features
- 100% bolt-on design for easy installation
- Bump stop extensions properly limit up-travel, protecting your vehicle
- Heavy-duty upper and lower control arms improve strength and articulation while correcting caster
- Heavy-duty front track bar bracket correctly positions front axle under vehicle
- Steering components included to ensure smooth post-installation operation of steering system and factory-consistent vehicle handling characteristics
Specifications
- Front Lift Method: Coil Spring
- Front Lift Height: 3"
- Rear Lift Method: Block
- Rear Lift Height: 3"
- Shocks Included: Yes
Installation
- Estimated Installation Time: 6 hours
- Installation Difficulty: Moderately Easy
Important Notes
- This truck was produced using rear axles of differing diameters; measure the diameter of your rear axle to ensure proper kit selection in configuration.
- This kit is not designed for dually models, but may be easily adapted to accommodate your truck. Please contact customer support and they will help you find a solution.
- Gas Engine? Gas models may sit slightly taller than the advertised lift height due to lighter weight of engine.
- Two-piece rear drive shaft? Add a carrier bearing drop kit to reduce post-lift driveline angles and avoid/eliminate driveshaft vibration.
Total Reviews (0)
Write the First Review!