ICON 00-05 Ford ExcursioICON 4.5in Suspension System | K44000-99

APPLICATION NOTE #17: THESE ARE STAND-ALONE KITS AND ARE NOT TO BE USED IN CONJUNCTION WITH ANY OTHER AFTERMARKET KITS APPLICATION NOTE #3: NO FRONT DRIVESHAFT MODIFICATION NEEDED. STOCK DRIVESHAFT IS FULLY FUNCTIONAL. APPLICATION NOTE #5: 2001-2004 3” And 4.5” Hanger Kits Come Complete With A New Replacement Front Cross-Member. This Crossmember Replaces The Factory Crossmember OEM Wheels & Tires Fitment: Yes Recommended Aftermarket Tires: 35" x 12.50" (Larger tires may fit but fender trimming and modifications will be required.) Recommended Aftermarket Wheels: ICON Alloys - 17x8.5" w/ 5.00” Backspace / 6mm Offset Recommended Aftermarket Wheels: ICON Alloys - 18x9" w/ 5.25” Backspace / 6mm Offset Recommended Aftermarket Wheels: ICON Alloys - 20x9" w/ 5.25” Backspace / 6mm Offset

4.5" HANGER SUSP SYS ICON 00-05 Ford ExcursioICON 4.5in Suspension System

• No drive shaft modifications needed
• 100% Bolt-on system - no drilling, cutting or welding necessary for install
• Isolates Stock springs for Factory Like Ride Quality
• Less body-roll than stock truck
• No change in towing capacity
• Durable powder coat finish
• Increased wheel travel

This 4.5" system is designed to lift your Ford Excursion 4.5" in front to provide room for 35” tires. This system drops your stock springs 4.5", which allows for 4.5" of lift while maintaining the stock spring rate. This system comes with a 1.75" bump stop spacer to prevent spring fatigue during the suspension cycle. Also included in this kit is 5” rear block kit, with 17” U-bolts for a leveled stance. This system is the ideal for all Excursion’s.