6 Inch Lift Kit | 2009-2013 Dodge Ram 2500/3500 4WD Diesel | 4 Inch Axle | w/ Nitro Series Shocks | Zone Offroad

Configured for trucks with a 4 inch rear axle diameter. Includes Nitro Series shocks featuring an internal floating piston (IFP) monotube design, a large 5/8-inch hard chrome plated heat-treated alloy steel shaft, race-developed high-flow piston design, application-specific valving, and a long-lasting silver coated finish.

Overview

This 6-inch lift kit is designed for 2009–2013 Dodge Ram 2500/3500 diesel 4WD trucks. It provides 6 inches of front lift via coil springs and 4 inches of rear lift via blocks, allowing fitment of up to 37-inch tires. High-strength control arm relocation brackets correct suspension geometry and add rigidity. The kit uses a 100% bolt-on design for straightforward installation.

Features

• 100% bolt-on design for easy installation
• High-strength control arm relocation brackets correct suspension geometry and add rigidity
• Shocks included with every configuration
• Available for both 3-1/2 inch and 4 inch rear axle diameters
• Choice of FOX 2.0 Adventure Series or Nitro Series shocks

Specifications

• Front Lift Method: Coil Spring
• Front Lift Height: 6 inches
• Rear Lift Method: Block
• Rear Lift Height: 4 inches
• Shocks Included: Yes

Installation

• Estimated Installation Time: 7 hours
• Installation Difficulty: Moderate

Important Notes

• This truck was produced using rear axles of differing diameters; measure the diameter of your rear axle to ensure proper kit selection in configuration.
• Although rare, if you experience front driveline vibration, install the optional transfer case indexing ring.
• This kit is not designed for dually models, but may be easily adapted to accommodate your truck. Please contact customer support and they will help you find a solution.
• Gas models may require modification to the front exhaust crossover pipe on driver side when using the transfer case indexing ring.
• Two-piece rear drive shaft? Add a carrier bearing drop kit to reduce post-lift driveline angles and avoid / eliminate driveshaft vibration.
• Adding larger-than-stock wheels? Add front bumper spacers to your kit for additional clearance as some wheel / tire combos may not fully clear the bumper's stock location.
• Works on 2013 2500 with 4 link front suspension only.
• Will not fit 1 Ton Trucks.