Alignment Cam Kit | 2.3° Caster Correction | 2005-2025 Ford F-250/F-350 Super Duty 4WD | Zone Offroad

Overview

Zone Offroad's alignment cam kit is designed for 2005–2025 Ford F-250/F-350 Super Duty 4WD trucks that have been lifted or leveled. These bolt-on replacement cams swap out the factory upper ball joint cams to add 2.3 degrees of caster over stock, correcting steering geometry for improved handling after a suspension lift or leveling installation.

Features

• Adds 2.3 degrees of additional caster without increasing the front driveshaft operating angle
• Compatible with most lift and leveling kits on the market to improve caster
• Direct bolt-on replacement for factory upper ball joint cams
• Sold in pairs

Installation

• Estimated Time: 1–3 hours
• Difficulty: Moderately Easy

Important Notes

2024+ Ford Super Duty Only: This kit includes ball joint cams to achieve optimum performance both on and off-road. For vehicles equipped with a non-selectable passenger side hub-lock on the front axle along with these ball joint cams, it is required to replace the non-selectable hub-lock with a selectable hub-lock. Part number PC3Z-3B396-A is needed to prevent a grinding noise from the front axle for these applications. If your vehicle is not factory equipped with them, you may also need vacuum lines (3C125-A and/or 3C124). You can reference Section 307-07A of the Workshop Manual or Bulletin SSM 52423 for more information. See installation instructions for additional information.