Configured with the 2 Inch Block Kit With Overload rear lift — select this option if your RAM 3500 is equipped with factory rear overload leaf springs. Includes the FOX 2.0 Factory Race Series Hydraulic Bump Stop for the front, engineered to absorb big impacts and maintain control at speed over rough terrain. Built around the standard 6-Bolt indexing ring kit, compatible with the standard transfer case bolt pattern.
Overview
The BDS 4-Inch Radius Arm Lift Kit for 2019–2024 RAM 3500 4WD Diesel replaces the factory front suspension setup with a coilover conversion system featuring FOX 2.5 Performance Elite coilovers, delivering enhanced control, improved ride quality, and precision damping on and off the road. Heavy-duty BDS radius arms replace the stock units to improve articulation, correct caster, and maximize ground clearance. FOX Performance Elite rear shocks provide controlled, smooth performance over varied terrain. An optional FOX 2.0 hydraulic bump stop for the front is available to add an additional layer of absorption during high-impact off-road use.
Features
- FOX 2.5 Performance Elite coilovers mount in the factory coil spring bucket
- FOX 2.5 Performance Elite rear shocks
- Optional auxiliary front FOX 2.0 hydraulic bump stop
- Heavy-duty tubular steel radius arms that correct caster while maximizing ground clearance
- Front adjustable track bar allows the front axle to be re-centered after lifting
- Front sway bar correction to maintain handling performance
Specifications
- Front lift: 4 inches via coilover conversion
- Rear lift: 2 inches via block kit
- Rear block kit available with or without overload configuration to match factory rear leaf spring setup
- Indexing ring kit available in 6-bolt (standard) or 8-bolt (Aisin transmission) configurations
- 8-bolt kit includes internal shaft seal extension and new shaft seal
Installation
- Estimated Time: 7–8 hours
- Difficulty: Difficult
- Special Tools Required: 8677 Chrysler ball joint separation tool (or equivalent)
Important Notes
- Will not fit air ride equipped models
- Diesel models only
- Requires aftermarket front driveshaft due to increased wheel travel
- Dually with 8-bolt Transmission (Aisin) requires BDS122409 DEF Relocation Kit
- Mega Cabs with 8-bolt Transmission (Aisin) require BDS122409 DEF Relocation Kit
- Vehicles equipped with a Manual T-case require BDS122423 Manual transfer case shifter extension
- Vehicles equipped with a 2-piece rear drive shaft (carrier bearing) require BDS122406 Carrier Bearing Drop
Total Reviews (0)
Write the First Review!